Site selection: The air energy water heater installation should choose a horizontal orientation that can accept the weight of the equipment without adding noise and vibration.

Space reservation: The orientation of the device should be convenient for maintenance and protection, and maintenance space should be reserved.

Equipment connection: Flexible connection is selected between the unit and the hot water outlet pipe, circulating water pipe, and tap water inlet pipe to prevent vibration from being transmitted from the unit to the water pipe.

Equipment protection: The rigid pipeline of the host should use spring vibration reduction brackets to prevent the pipeline from transmitting vibration to the building.

Temperature monitoring: Install a water pressure gauge and thermometer for maintenance and repair purposes.

Drainage treatment: Align the drainage pipe with the drainage pipe joint that pierces into the bottom of the heat pump water heater chassis, and then introduce it into the sewage pipe.

Pipeline insulation: Water pipes should be well insulated to prevent energy loss.

Protective space: There should be sufficient space left outside the unit.

Application environment: The ambient temperature is required to be between -5 and 45 degrees Celsius to prevent use in low temperature environments, otherwise it may lead to a decrease in energy efficiency.

Device protection: If multiple direct heating water heaters are installed, the distance between the units and the pipeline installation must comply with corresponding rules.

Operation and application: Set the water temperature to heat the predetermined temperature, and the temperature should not exceed 65 degrees to prevent equipment damage caused by excessive temperature.

Article source: Dongguan air energy water heater Www.gdhyxny.com